Fabrication CADmep
Join the Autodesk Fabrication CADmep community discussions to help share and receive technical product knowledge, insight, tips and tricks.

Fabrication CADmep

Reply
Active Member
davidbrewer9029
Posts: 9
Registered: ‎01-28-2010
Message 1 of 3 (357 Views)

Problems with Service Pack 2

357 Views, 2 Replies
12-18-2013 09:04 AM

Do not install Service Pack 2, it plays havoc with your database.  Our ITMs start to self reference their own Specification causing a Specification Mismatch alert for almost every part.  Everytime you edit a part it causes a new bogus entry in the Main Database that can't be deleted.  If you edit a part and set the Specification to what it should be, the spec will revert when you save.  These problems came to light we I was importing a service into a new profile and nothing worked properly.

 

Reverting to SP1b seems to fix these problems.

Active Contributor
cadbob
Posts: 76
Registered: ‎07-11-2011
Message 2 of 3 (174 Views)

Re: Problems with Service Pack 2

01-08-2014 05:36 AM in reply to: davidbrewer9029

Not sure if you or Anyone who reads this knows, but the problem with SP2 has been fixed. Autodesk Web Site still shows Hypertext as SP2 but will Download SP2B which is good!

I don't believe you can do today's job with yesterday's methods and be in business tomorrow.
Active Member
davidbrewer9029
Posts: 9
Registered: ‎01-28-2010
Message 3 of 3 (168 Views)

Re: Problems with Service Pack 2

01-08-2014 06:23 AM in reply to: cadbob

Yes, the database problem has been fixed in SP2b.  Thanks for the heads-up.  But the problem with small bore pipe with insulation has gotten worse. Try to view a drawing with one of these elbows in Navis and it will zoom to infinity, in AutoCAD a zoom extents zooms to infinity.

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.