Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am just staring to use Aurocad 2014 with the Autodesk Fabrication CADMEP. I cannot get my duct elevations to display in 1/8" increments. If I move the duct 1/8" it will give the elevation in either 1/4" or 1/2", it will not display 3/8, 5/8 7/8" increments for the bottom or top elevation of duct. In the Dimstyle Manager I have the precision set to 1/16". I also have the drawing units set to 1/16" precision. Is there somewhere else in the program that could be overriding this?
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")