Dynamic Blocks

Dynamic Blocks

Reply
New Member
LKGCAD
Posts: 1
Registered: ‎10-10-2011
Message 1 of 3 (6,275 Views)

Weld Symbol Dynamic Blocks

6275 Views, 2 Replies
10-10-2011 01:43 PM

 I noticed a lot of users looking for dynamic Weld Block Symbols,  I have attached a set that I have created.  The descriptions are below.  The attached file show an example of its use and contains the five blocks.  Text style is set to "STANDARD".

 

There are five blocks which can be added to an existing leader:

 

Weld_Symbols  -> This is the main dynamic block of weld symbols to cover welds described in the AWS A2.4 standard, size and spacing attributes can be edited, make sure MIRRTEXT is set to 0 if using vertical flip function for welds opposite arrow side

 

Weld_Options  - >  This dynamic  block allows for the addition of either or both of the Field-Flag and All-Around symbols as well as a combination-fillet weld symbol to be added to an existing bevel or square weld, etc. when needed, field flag is flippable for proper direction

 

Weld_Contour  - >  This dynamic block allows for the flush, concave or convex contour symbols to be applied to both fillet type welds and non-fillet type welds; a designator can be added by attribute edit for countour finish letter

 

Weld_Tail_Left -> This dynamic block gives you a single, double or triple line option for attribute text, default is a single line of text with "TYP", left tail is for left side of symbol therefore right justified text

 

Weld_Tail_Right -> This dynamic block gives you a single, double or triple line option for attribute text, default is a single line of text with "TYP", right tail is for right side of symbol therefore left justified text

 

 

Remember, once you have one weld symbol in place, it is much easier to copy and use dynamic grips to manipulate it rather than inserting several times as with all dynamic blocks.

 

Regards,

Lance G.

 

Active Member
cemnet
Posts: 8
Registered: ‎10-05-2012
Message 2 of 3 (4,918 Views)

Re: Weld Symbol Dynamic Blocks

11-16-2012 05:50 AM in reply to: LKGCAD

Thank you

New Member
t90cline
Posts: 1
Registered: ‎08-28-2013
Message 3 of 3 (997 Views)

Re: Weld Symbol Dynamic Blocks

05-14-2014 08:15 AM in reply to: cemnet

Yes, Thank you.

 

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.