Kiersten wrote:
> I hope I can explain this. I've created a block (1 unit wide x 1 unit tall) where I can stretch it either horizontally OR vertically and create any combination of units wide and tall. BUT, I'd like to just pull at a corner point and increase it horizontally AND vertically at the same time, again, being able to create any combination of units wide and tall (NOTE: the width and height are not the same distance and I'm controlling them incrementally, by their width or height distance). A
> lso, if I stretch it to the left or down, the grip points stay at the original base point, rather than "sticking" to the endpoints of the square. Is there anyway to adjust that? I've attached my block with what I have so far, if anyone's willing to take a look. I'm at my wit's end.
Is this what you are trying to accomplish? This was done using the XY
Stretch Box Set, which includes an XY Parameter, and four stretch actions.
--
Brian Winterscheidt
LWPB Architects & Planners, P.C.
Oklahoma City, Oklahoma