Dynamic Blocks

Reply
Valued Mentor
mdhutchinson
Posts: 2,302
Registered: ‎11-18-2003
Message 1 of 2 (156 Views)

FIT justification for Attributes

156 Views, 1 Replies
12-13-2012 06:03 AM

I been doing AutoCAD Blocks since AutoCAD version 9

Now in 2013... Sometimes FIT option works for me...

... most times it does not.

 

Has anyone had any trouble with this - and or - found a work-a-round preceedure?

 

One point though: The block is Annotative = Yes...

If I set this to NO, in the block where it isn't working then it works as it should. However, strange as it seems... both the versions are Annotative...

 

 

Valued Mentor
AcadAdamLT
Posts: 493
Registered: ‎12-14-2010
Message 2 of 2 (137 Views)

Re: FIT justification for Attributes

12-14-2012 04:15 AM in reply to: mdhutchinson

I havn't had any problems yet with the "Fit" option in 2013 yet.

Does the block have any dynamic properties that could give the fit attribute any problems?

Signature, sincerely... //Adam
AutoCad LT 2014
Give Kudos where credit is due, Mark "accepted as solution" if the post solved your question.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.