DWG TrueView

DWG TrueView

Reply
New Member
BrettK39
Posts: 2
Registered: ‎06-21-2013
Message 1 of 2 (1,083 Views)

TrueView 2014 Extraction Failure

1083 Views, 1 Replies
06-21-2013 01:27 PM

   I downloaded 64-bit DWG TrueView 2014 to Win. 7 Home Prem. 64-bit as Administrator & ran the Setup file. It tried to extract the files but the progress bar never moved. I started over 2 more times w/o success. I tried 32-bit ver. 3 times.

   After reading the Discussion Group Posts (DGPs), I found 1 possible relevant suggestion: turn off AntiVirus S/W. I turned off my Norton Internet Security's AV, AntiSpyware, & Insight & SONAR Protection. Two more attempts w/ both versions of DTV failed.

    I checked DGPs again & on a lark, I decided to try a suggestion that didn't exactly fit my problem. That was phillip.s's 6-4-12 response to the TrueView download post by philip. His problem was downloading. The solution was a direct download link to DTV 2013. I'm not including the links since I didn't see many posts w/ a problem similar to mine & I'm short for time.

   I tried the 64-bit ver. link. It downloaded, it extracted files, & it installed (after the 2nd attempt). After the 1st installation attempt, I had to download & install .NET Framework 4 Full ver. because Framework 4 Client Profile, which was already installed, wasn't the correct ver. 4 that DTV requires. I doubt that deficiency was the problem w/ DTV 2014 because DTV 2013 alerted me to the problem. Certainly the new & "improved" DTV 2014 would've done the same.

New Member
j_alefbitencourt
Posts: 2
Registered: ‎09-30-2013
Message 2 of 2 (794 Views)

Re: TrueView 2014 Extraction Failure

09-30-2013 06:49 AM in reply to: BrettK39

Se ajudar  ...

 

Após quase um mês tentando, descobri o que estava travando a extração (pelo menos no meu caso): Macafee anti-vírus.

 

Tive que remove-lo para a extração não travar. Após a remoção do Macafee, a extração ocorreu normalmente e a instalação também. Depois reinstalo o anti-vírus.

 

-------------------------------------------------------------------------------------------------------------------------

 

If it helps ...
After almost a month trying to discover what was waging extraction (at least in my case): Macafee anti-virus.


I had to remove it for the extraction does not crash. After removal of Macafee, the extraction and installation normally also occurred. Then reinstall the anti-virus.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.