Is there a way to change the precision of the measurement in Trueview 2010?
ie. when I measure 47.5 in. (it rounds up to 48).
Or is this something that is brought over from the original AutoCad dwg?
>>>this<<< is the forum for TrueView (here we have AutoCAD 2010, it's different)
Good luck, - alfred -
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!