The application was unable to start correctly (0xc0000142). Click ok to close the application.
Version windows 7 pro 64 bit.
I have tried uninstalling reinstalling.
and I have tried reinstalling .net framework 4.5
thanks for any help you can provide.
I have same problem... When I install dwgviewer and try to start it, I recive a message:
"The application was unable to start corectly (0xc00000142). Click OK to close the application."
I reinstall the dwgviewer two times...
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!