DWG TrueView

DWG TrueView

Reply
Member
unfamiliar2
Posts: 3
Registered: ‎10-12-2011
Message 1 of 4 (1,490 Views)
Accepted Solution

DWGs Trying to Open in Adobe, not True View

1490 Views, 3 Replies
01-04-2013 08:00 AM

Recentnly, I installed a 64-bit version of DWG True View.  Now, when I go to open a DWG file, Abobe Reader opens and displays the following message:

 

"Adobe Reader could not open 'xxx.dwg' because it is either not a supported file type or because the file has been damaged."

 

Is there any way to change the settings to enable DWG files to open through DWG True View, as opposed to Adobe Reader?  Is there an AC Launcher associated with True View where I would make the setting changes?  If so, where is the AC Launcher file located in True View?

 

Thanks.

Hello Stephen,

 

You're going to need to make sure that DWG True View is setup as the default program for .dwg files. To do so, open your Control Panel -> Programs -> Default Programs -> Set Associations / Associate a file type or protocol with a program -> .dwg -> Change program.

 

Hope that helps and please accept as a solution if this fully resolves the issue, or reply with additional specifics as needed.

Community Manager
philip.s
Posts: 2,674
Registered: ‎09-27-2011
Message 2 of 4 (1,486 Views)

Re: DWGs Trying to Open in Adobe, not True View

01-04-2013 09:13 AM in reply to: unfamiliar2

Hello Stephen,

 

You're going to need to make sure that DWG True View is setup as the default program for .dwg files. To do so, open your Control Panel -> Programs -> Default Programs -> Set Associations / Associate a file type or protocol with a program -> .dwg -> Change program.

 

Hope that helps and please accept as a solution if this fully resolves the issue, or reply with additional specifics as needed.



Philip Schmelzer
Member
unfamiliar2
Posts: 3
Registered: ‎10-12-2011
Message 3 of 4 (1,479 Views)

Re: DWGs Trying to Open in Adobe, not True View

01-04-2013 10:09 AM in reply to: philip.s

Peter,

 

I knew that it had to be something simple.  Thanks for the help.

 

Stephen

Member
unfamiliar2
Posts: 3
Registered: ‎10-12-2011
Message 4 of 4 (1,478 Views)

Re: DWGs Trying to Open in Adobe, not True View

01-04-2013 10:10 AM in reply to: unfamiliar2

*Philip.  My mistake.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.