DWG TrueView

DWG TrueView

Reply
Active Member
Donpk123
Posts: 6
Registered: ‎03-11-2010
Message 1 of 2 (1,584 Views)

DWG TrueView 2013 Angle Measurement Problem

1584 Views, 1 Replies
09-01-2012 11:50 AM

The angle measurement tool does not produce the results I would normally expect.

 

For example, if I have two lines, one vertical and the other horizontal,  at 90° with a common vertex and I click I both lines with the angle measurement tool, the results show 0.0° instead of 90°.  A third line, 20° CCW from the horizontal line, shows an angle of 70°, instead of 20°

 

Am I doing something wrong, or is there a problem with the angle measurement tool?

 

Thanks,

   Don

Member
autodeskuser234
Posts: 3
Registered: ‎03-07-2013
Message 2 of 2 (960 Views)

Re: DWG TrueView 2013 Angle Measurement Problem

03-08-2013 01:17 AM in reply to: Donpk123

Are you using Ctrl 9?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.