I am trying to convert an v2011 .dwg file to a v2007 .dwg with DWG True View to open it in v2008. It seems to do the conversion but when I open it in v2008 I still get the message "This drawing was created with a newer version of Civil 3D. All entities created by civil 3D within the drawing are in a proxy state. Additionally, all commands, settings, and displays of Civil 3D are disabled for this drawing." Is it not actually converting or is this just a Civil 3D issue? If it doesn't convert the Civil 3D entities what is the difference in converting with DWG True View and just doing a "save as" to an earlier version.
Also why would it disable all of my Civil 3D commands so that I can't create any new v2008 Civil 3D entities?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!