DWF Viewer

Reply
Active Contributor
Kiersten
Posts: 44
Registered: ‎09-03-2003
Message 1 of 2 (167 Views)

Layer Isolate command generating an error.

167 Views, 1 Replies
12-17-2002 11:35 PM
We're using Express Tools 2000 on ADT3.3 with a Windows 2000 o.s. One of our users is experiencing inconsistent results with the Layer Isolate command. Occasionally it works fine, other times it generates the error "rejected "clayer" 0ROOF1" - in the same drawing (and the layer 0ROOF1 is unlocked). Any ideas?
*Bell, R. Robert
Message 2 of 2 (167 Views)

Re: Layer Isolate command generating an error.

12-18-2002 10:38 AM in reply to: Kiersten
Wrong ng.

 

But it is likely that the layer is frozen. A frozen layer
cannot be set current with (setvar "clayer" layername), it will
barf.

 


 

 


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
We're
using Express Tools 2000 on ADT3.3 with a Windows 2000 o.s. One of our users
is experiencing inconsistent results with the Layer Isolate command.
Occasionally it works fine, other times it generates the error "rejected
"clayer" 0ROOF1" - in the same drawing (and the layer 0ROOF1 is unlocked). Any
ideas?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.