Drafting Techniques

Drafting Techniques

Reply
Distinguished Contributor
bjenks
Posts: 148
Registered: ‎09-27-2006
Message 1 of 5 (290 Views)
Accepted Solution

Electrical Switch/Receptacle note directions

290 Views, 4 Replies
07-23-2012 10:38 AM

I am trying to figure out if there is any standard or preferred way to put switches and receptacles on a drawing with type and group symbols.  I personally always make the facing the wall on the right side, but that makes them upside down in certain situations.  I would be interest in peoples comments by selecting a number for each wall on the standard they have or know about.

 

Switches.JPG

*Expert Elite*
GrantsPirate
Posts: 1,593
Registered: ‎08-15-2008
Message 2 of 5 (285 Views)

Re: Electrical Switch/Receptacle note directions

07-23-2012 04:09 PM in reply to: bjenks

They should read from the bottom or right side of the drawing like any other text, dim, etc. in a drawing.  Don't put text upside down.

----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.
Distinguished Contributor
bjenks
Posts: 148
Registered: ‎09-27-2006
Message 3 of 5 (277 Views)

Re: Electrical Switch/Receptacle note directions

07-24-2012 05:17 AM in reply to: GrantsPirate

So for the top you would say #3, bottom #9, but what number would you pick for the right and left?

*Expert Elite*
GrantsPirate
Posts: 1,593
Registered: ‎08-15-2008
Message 4 of 5 (275 Views)

Re: Electrical Switch/Receptacle note directions

07-24-2012 05:57 AM in reply to: bjenks

I would use 5 for left or right, and 4 if there were space constraints.

----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.
*Expert Elite*
GrantsPirate
Posts: 1,593
Registered: ‎08-15-2008
Message 5 of 5 (258 Views)

Re: Electrical Switch/Receptacle note directions

07-24-2012 07:44 PM in reply to: bjenks

You need to use 9 for top and bottom, 8 if space constraints.

----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.