Design Review

Design Review

*Expert Elite*
Posts: 3,421
Registered: ‎04-06-2010
Message 1 of 1 (126 Views)

Vault Visualizations 2013

126 Views, 0 Replies
06-18-2012 04:36 AM

Kudos to the development team for getting some dynamic stamps into the 2013 DR product.  Very nice.  Now.... why can we not check DWF files into or out of Vault?


Specifically what I would like is this:  When Vault creates a visualization file for an item, I can right click and select "Open in Design Review".  But I cannot make a change or markup... or add that nice new stamp... and then put it BACK into the Vault as the visualization file.  The whole point of asking for the stamps was so that our visualizations could be stamped by the approving engineer and then seen by users all over the plant through the Vault web client.


We're so close... just one more step and we'll be there!



Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.