Design Review

Reply
Valued Contributor
masa10789
Posts: 56
Registered: ‎09-02-2004
Message 1 of 5 (324 Views)

Close a markup

324 Views, 4 Replies
04-30-2007 08:54 AM
Is there a command to close a markup in AutoCAD? I'd like to find a command or even close it programmatically, as a workaround to having to use the markup palette. Thanks in advance.
Contributor
malini
Posts: 16
Registered: ‎07-06-2007
Message 2 of 5 (324 Views)

Re: Close a markup

07-06-2007 11:12 AM in reply to: masa10789
Could you please clarify, Are you looking to close/collapse a markup on the sheet?

Malini Bakshi
Autodesk
Valued Contributor
masa10789
Posts: 56
Registered: ‎09-02-2004
Message 3 of 5 (324 Views)

Re: Close a markup

07-06-2007 12:20 PM in reply to: masa10789
I am looking for a programmatic way or an autocad command to close (dettach) an attached markup from a drawing. So after I attach a markup and am finished using it, I want to close (dettach) it from my drawing. But the only way I know how to close (dettach) it is to use the markup palette and choose the option "Close Markup DWF". IIs there any way to dettach the markup without having to use the markup palette?
Member
malinibakshi
Posts: 4
Registered: ‎07-20-2007
Message 4 of 5 (324 Views)

Re: Close a markup

07-20-2007 10:35 AM in reply to: masa10789
I'll try to get a reply for you shortly.

In the future, I'd suggest posting AutoCAD questions in the AutoCAD Discussions group, (this is the ARD Group).

Thank you.
Malini Bakshi
Autodesk
Contributor
malini
Posts: 16
Registered: ‎07-06-2007
Message 5 of 5 (324 Views)

Re: Close a markup

07-20-2007 12:22 PM in reply to: masa10789
Here's what I've found out from our ACAD Designer.

There is no command to close a markup DWF. 
Can you give some info on the reason the user might want to do this?

If there were a command to close a marked DWF it would need to allow discreet selection of one of the many DWF markups. An alternative to this would be to leave the markup open and create a command to toggle the display of the DWF markups on/off as well as display of the DWF geometry. This would be similar to the existing controls in the Markup Set Manager.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.