Configurator 360 General Discussion

Configurator 360 General Discussion

Reply
Contributor
martyn
Posts: 11
Registered: ‎02-28-2007
Message 1 of 3 (292 Views)
Accepted Solution

Input value limits

292 Views, 2 Replies
03-18-2014 06:55 PM

Hello

 

Can the limits of an input value be made as a formula?

 

If you have a "Length" value can you then use this as a limit for another value.

 

"Width" may have a minimum of "150mm" and a maximum of "Length-150mm"

 

Thanks

 

 

 

 

Sanjay

No worries, thanks for the prompt reply

Maybe something for the wish list?

Marty

Board Manager
sanjay.ramaswamy
Posts: 112
Registered: ‎11-13-2007
Message 2 of 3 (274 Views)

Re: Input value limits

03-19-2014 04:51 PM in reply to: martyn

Sorry, expressions are not currently supported in the Configurator 360 interface. Of course, you can have iLogic rules in Inventor check & enforce these limits.

 

Sanjay-

Contributor
martyn
Posts: 11
Registered: ‎02-28-2007
Message 3 of 3 (270 Views)

Re: Input value limits

03-19-2014 06:52 PM in reply to: sanjay.ramaswamy

Sanjay

No worries, thanks for the prompt reply

Maybe something for the wish list?

Marty

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.