Need to start a new forum for the recently acquired Fabrication (MAP) software
Solved! Go to Solution.
Someone else looking for it -->>>> Exporting to FabMep
AUGI's got one now....just sayin'
Awesome! that's great to hear, thanks!
BTW, if you saw a previous post that i deleted, it's because someone was messing with us and i got fautly information about xtracad. but would still love to see the forum here on the autodesk site instead.
No problem! There's been demand from a few different sources to get a Fab forum up and running, and rightfully so. I'll keep you posted.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!