I set up a profile, set my vertical alignment, created the corridor, surface. So I am plugging along and all of a sudden my profile is 147 feet off. The corridor surface has not been affected. What has happened?
PDF is attached.
Solved! Go to Solution.
Solved by Chaznsc. Go to Solution.
Are there any surface edits that may explain this?
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
@hkam111 - I will check that this morning.
@Joe-Bouza - I dont think so, but I was working on storm structures. Its the damndest thing, the profile has not affected the corridor surface.
So I went into the table editor and dropped the elevations, all seems to be normal again. Refereshed the corridor and its good.