Does anyone have any experience using a Sheet Set (DST file) or Project Navigator (APJ file) on a project completely stored on Buzzsaw?
I would like to use a DST or APJ file but don't think Buzzsaw fully supports these.
All of the DWG files will be stored on a Buzzsaw Site and NOT on our local drivers or servers.
I know I can post the DST or APJ file to Buzzsaw and check it in and out.
But if the drawing files the DST or APJ references are NOT on my local drive or server I don't think it will work.
Maybe I am missing something but I think I am out of luck.
Any insight would be greatly appreciated.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The Buzzsaw forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!