Buzzsaw General Discussion

Buzzsaw General Discussion

Reply
*Expert Elite*
scot-65
Posts: 2,210
Registered: ‎12-11-2003
Message 1 of 1 (114 Views)

Importing a sheetless DWF into Buzzsaw?

114 Views, 0 Replies
03-04-2011 10:39 AM

I have a client that requests DWF files so he can plug into his Buzzsaw editor.

We sent him files using the export command but they will not import.

We do not use sheet sets - could that be the problem?

 

The following steps is what we do to create the DWF files:

- Display the current page using freeze/thaw method while in model space.

- File -> Export -> 3D.dwf, name the file.

- Repeat for each page of our document set.

 

The result is 8 DWF files - one for each of the 8 pages.

I have tried to DWFATTACH back into my (R2007) editor but get an error

message that there is no sheets in the DWF.

 

In lieu of having to create sheet sets (to which I cannot do at this time)

I was wondering if there is any way my client can successfully import

the DWF files I have created, in this present form?

 

I do not know if he has just a DWF viewer or a full-blown DWF editor...

 

Scot-65

Scot-65
Dyslexia is a permanent physical disability that cannot be seen.
Introverts is proof that there is indeed intelligent life on this planet.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New Buzzsaw Category!

The Buzzsaw forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.