Buzzsaw General Discussion

Buzzsaw General Discussion

Reply
Active Contributor
orbjeff
Posts: 31
Registered: ‎08-15-2011
Message 1 of 2 (1,189 Views)
Accepted Solution

Buzzsaw doesn’t sync example#.nwc

1189 Views, 1 Replies
08-15-2011 11:22 AM

Hi There,

 

Navisworks 2012 creates files with a # symbol in the filename. Buzzsaw Sync won’t sync these files given the # symbol in the file name. Since there is a good reason Navisworks now adds this # symbol, removing it is not an option. Is there anything we can do from the Buzzsaw Sync end to overcome this issue?

 

Thank You,

 

Jeff Johnson

Jeff Johnson
Technical Consultant
DataWorks MGI | a division of MasterGraphics Inc.

Unfortunately there's not, the # is added due to the introduction of 2D support to the Navisworks 2012 release. We have passed on the issue to development and we're looking to change the way we handle NWC files in the future.

Product Support
lee.mullin
Posts: 479
Registered: ‎10-02-2007
Message 2 of 2 (1,178 Views)

Re: Buzzsaw doesn’t sync example#.nwc

08-16-2011 02:03 AM in reply to: orbjeff

Unfortunately there's not, the # is added due to the introduction of 2D support to the Navisworks 2012 release. We have passed on the issue to development and we're looking to change the way we handle NWC files in the future.


Lee Mullin
Product Support Specialist
Global Services
Autodesk Ltd.


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New Buzzsaw Category!

The Buzzsaw forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.