AutoSketch

Reply
New Member
2 Posts
0 Kudos
Registered: ‎07-07-2009
Post 1 of 3

Trimming objects

153 Views, 2 Replies
07-07-2009 08:18 AM
Is there a way to trim off a line segment that extends past a perpendicular line?
*Richard Herman
Post 2 of 3

Re: Trimming objects

07-07-2009 10:33 AM in reply to: eweis
eweis schreef:
> Is there a way to trim off a line segment that extends past a perpendicular line?

Hello,

I'm not exactly sure what you mean, but I assume you mean two lines that
would intersect, but don't, because one is too short.

In that case you could just use 'edit' > 'trim' > 'edge'

But maybe i don't understand the question correct.

Richard
Contributor
11 Posts
0 Kudos
Registered: ‎11-30-2009
Post 3 of 3

Re: Trimming objects

11-30-2009 11:41 PM in reply to: eweis
I'm not sure if I'm understanding your question either, but if you're just "trimming excess" off of a line, you should marquis the area by using a window, then using the command line: TR (for trim), and just click the piece you want to get rid off. If the piece isn't being trimmed, then it's because of the reply before mine, there is no intersection. In that case, zoom in and check.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!