AutoSketch

Reply
Contributor
joshman
Posts: 16
Registered: ‎07-23-2008
Message 1 of 2 (947 Views)

SKF Autosketch file conversion?

947 Views, 1 Replies
01-19-2012 02:47 PM

Greetings,

 

I have an old copy of Autosketch 6. I cannot install this on any 32bit or higher system, which means I'm screwed. I have a whole bunch of archived drawings from autosketch that are now unreadable.

 

Autosketch use to have an option to convert to a dxf which was handy to read in autocad but I can't load the old program; therefore, have no way of converting these files.

 

Is there a way to convert skf files to dxf or dwg?

*Expert Elite*
pendean
Posts: 22,930
Registered: ‎11-06-2003
Message 2 of 2 (936 Views)

Re: SKF Autosketch file conversion?

01-20-2012 09:56 AM in reply to: joshman
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.