AutoSketch
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

NEED TO TONE DOWN SNAP - CAN'T TRACE

2 REPLIES 2
Reply
Message 1 of 3
pbyrnej
932 Views, 2 Replies

NEED TO TONE DOWN SNAP - CAN'T TRACE

Whenever I insert an image into autodesk, I send it to it's own layer and lock it. But when I go back to layer one and start drawing the snap will default 100% to the image edges/corners and never right over the image. This makes drawing very trickey and SLOW!

 

Years back I traced within AutoCAD 2008 and I NEVER had this issue. Please tell me how I could tone down the snap or make the image visible but completely ignored by snap.

 

Thank you very much,

 

pbyrne

2 REPLIES 2
Message 2 of 3
StevenMac
in reply to: pbyrnej

It's a shame you can't define the boundary of the cursor. I use a combination of hide layer and disable snap settings - what else can you do...

Message 3 of 3
pbyrnej
in reply to: StevenMac

I wish Autodesk would release an update for AutoSketch 10, to correct this. IMO if a layer is locked it shouldn't be interacted with at all.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report