AutoSketch

AutoSketch

Reply
Active Member
siegert.martin
Posts: 8
Registered: ‎06-24-2011
Message 1 of 2 (419 Views)

How to thicken a thin line in both directions?

419 Views, 1 Replies
06-24-2011 03:12 AM

Hi,

 

I am looking for an option to thicken a thin line in both directions (from the middle). The result should then be a rectangle with two sides parallel to the initially painted line and two lines that close this parallel lines. In AS 2.1 there was an option "Width" --> from middle --> do not fill (or similar, I only have the german version).

 

Does this or a similar option exist in AS 10?

 

Thanks for your support. :smileyhappy:

 

Martin

Contributor
paul.wacko
Posts: 19
Registered: ‎01-16-2011
Message 2 of 2 (400 Views)

Re: How to thicken a thin line in both directions?

07-02-2011 10:09 PM in reply to: siegert.martin

Tht can be done with Polylines from the editbar.

 

Paul J

Paul Jackson
Western Australia
http://www.resolv.com.au
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.