AutoSketch

AutoSketch

Reply
Active Member
siegert.martin
Posts: 8
Registered: ‎06-24-2011
Message 1 of 2 (360 Views)

How to thicken a thin line in both directions?

360 Views, 1 Replies
06-24-2011 03:12 AM

Hi,

 

I am looking for an option to thicken a thin line in both directions (from the middle). The result should then be a rectangle with two sides parallel to the initially painted line and two lines that close this parallel lines. In AS 2.1 there was an option "Width" --> from middle --> do not fill (or similar, I only have the german version).

 

Does this or a similar option exist in AS 10?

 

Thanks for your support. :smileyhappy:

 

Martin

Contributor
paul.wacko
Posts: 19
Registered: ‎01-16-2011
Message 2 of 2 (341 Views)

Re: How to thicken a thin line in both directions?

07-02-2011 10:09 PM in reply to: siegert.martin

Tht can be done with Polylines from the editbar.

 

Paul J

Paul Jackson
Western Australia
http://www.resolv.com.au
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.