AutoSketch

Reply
Active Member
wcottr
Posts: 8
Registered: ‎07-21-2007
Message 1 of 2 (105 Views)

Edit marker points help needed

105 Views, 1 Replies
08-03-2007 04:34 PM
Hi guys - I have quite a few small diameter holes to show in a fairly small area. I would like to put marker points in the holes to show the centers but the markers also show outside the hole diameters. These marks outside the hole diameter get very distracting with a lot of holes close together. I could sure use some suggestions on how I could put a marker in the holes w/o going outside also. I sure appreciate all you kind folks willing to help us iggerant :smileyhappy: folks.
Active Member
wcottr
Posts: 8
Registered: ‎07-21-2007
Message 2 of 2 (105 Views)

Re: Edit marker points help needed

08-03-2007 07:51 PM in reply to: wcottr
Never mind guys - I figured it out - thanks.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.