Autodesk Factory Design Suite General Discussion

Autodesk Factory Design Suite General Discussion

Reply
New Member
RyanTweedt
Posts: 1
Registered: ‎06-28-2012
Message 1 of 1 (186 Views)

Problem with connector points

186 Views, 0 Replies
06-28-2012 01:03 PM

Hello,

 

I've been struggling with an issue for a couple of days now. I have a connector defined by a point on the same plane as the landing surface, but when I attach other assets to the connector, they are 0.00027143 in below the landing surface. I have tried redefining the connector point several different ways to try to get it to come out right, but nothing seems to work. The only way I can tell that it is wrong is to zoom in all the way. Normally this wouldn't be a big deal, but if I drop other assets in on the floor, and then try to snap them to they won't connect at all. This makes laying things out really hard, sometimes it is necessary to drop a part in and then rotate it in order to easily attach it.

 

I've attached a few pictures so you can see what's going on.

 

 

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.