Autodesk Architectural Desktop 2007 & Prior

Autodesk Architectural Desktop 2007 & Prior

Reply
*Barath, Dick
Message 1 of 3 (208 Views)

step footings

208 Views, 2 Replies
08-29-2003 02:11 AM
Could anyone share how they draw step footings.

Thank you

Dick Barath
*MacLeod, Arthur H.
Message 2 of 3 (208 Views)

Re: step footings

08-29-2003 08:33 AM in reply to: *Barath, Dick
One way I have done this is to use a single component wall style to draw the
footing only. Where you want to step the footing, just draw the lengths of
the steps. Then go back and set the Z locations for each step. Then draw the
wall itself over the wall footings. Finally, automatically project the
bottom of the wall down to the footings. Note the footings will not look
quite true in a 3D rendering as the steps do not sit on the next one lower,
but in plan they will show the risers correctly. Combining the footing with
the foundation wall with multiple components in a wall style has proven to
me more unwieldy than just drawing the footings as a style separate from the
walls.

Arthur
____________________________________________________________________________
_________


"Dick Barath" wrote in message
news:f185cbc.-1@WebX.maYIadrTaRb...
> Could anyone share how they draw step footings.
>
> Thank you
>
> Dick Barath
>
>
Distinguished Contributor
anniesball72
Posts: 145
Registered: ‎03-19-2009
Message 3 of 3 (175 Views)

Re: step footings

11-23-2011 09:24 AM in reply to: *MacLeod, Arthur H.

What do you set the wall base height to when doing a seperate footing from wall?

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.