Convert Splines to Walls?

[Anonymous]

I cannot convert splines to walls (ADT3.3). I am trying to create a freeform
shape for a wall, and ADT will not convert the spine to walls. Anyone with a
solution?

Thanks
Kurt Gibson

[Anonymous]

I ran into this problem too. The only thing I can think of is to export to
r12 dxf. When you import the dxf file in you will see the spline becomes
3dpline. You will have to explode it and convert them to pline the convert
to wall. However I've never been satisfied with this solution because it
creates many small segmented wall and it is very difficult to add doors,
windows...

Hope to hear any better solutions.

Toan

"Kurt Gibson" wrote in message
news:61351D445C8E61A4E9D59D56BD5D9C43@in.WebX.maYIadrTaRb...
| I cannot convert splines to walls (ADT3.3). I am trying to create a
freeform
| shape for a wall, and ADT will not convert the spine to walls. Anyone with
a
| solution?
|
| Thanks
| Kurt Gibson
|
|

[Anonymous]

Kurt Gibson wrote:

> I cannot convert splines to walls (ADT3.3).

Use SPL2PL.VLX from http://www.dotsoft.com/freestuff.htm to convert the
splines to polylines, then convert them to walls.

Terry