I am getting the same error while editing an xref in place.
** Application reference missing: AcDbBlockRepETag, to AcDbPolyline.
As a work around, remove the editted linework from the working set then discard the changes to the xref. Open the xref rather than editting in place and copy paste the revised linework back into the xref. Its a bit of a pain but better than losing your changes. Some feedback from Autodesk would be appreciated as it seems to be a common issue.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!