AutoCAD Utility Design General Discussion

AutoCAD Utility Design General Discussion

11 Posts
0 Kudos
Registered: ‎12-17-2008
Post 1 of 2

Line Labeling

1417 Views, 1 Replies
12-10-2009 01:01 PM
When I label a conductor the information is attached to and stored with the line but it does not show up on the screen unless invoked by the "View Facility Information" button. Is there anyway to have the condictor size show up on the drawing? I need all conductors labeled on the screen so they can be plotted with the drawings.

Thanks in advance for any help!

Heber Power
Active Contributor
37 Posts
1 Kudo
Registered: ‎10-02-2008
Post 2 of 2

Re: Line Labeling

03-11-2010 02:23 PM in reply to: heberpower
have you tried and used the UDSCALLOUTcommand?
this command will insert a block with attributes anywhere on the dwg and it can be set (created) with the descrpition of the selected object and or other values.

Jim bower
Spatial Network Solutions
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New Utility Design Category!

The Utility Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.