AutoCAD Utility Design General Discussion

AutoCAD Utility Design General Discussion

Distinguished Contributor
Posts: 924
Registered: ‎09-29-2005
Message 1 of 2 (401 Views)

Data Connetion

401 Views, 1 Replies
05-20-2013 10:59 PM


Can any one tell me how to establis data connection.




Electronics Engineer

Pind Saudi Arabia

Posts: 42
Registered: ‎12-18-2003
Message 2 of 2 (371 Views)

Re: Data Connetion

06-04-2013 11:38 AM in reply to: kulfi

Hi Kulfi,


Use the MAPCONNECT command to establish a connection to a data source.  The command works the same way in both AutoCAD Utility Design and AutoCAD Map 3D.  Documentation for this command can be found with your installed product. You can also find the documentation on line.  For example:



Bill Dhimitri

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New Utility Design Category!

The Utility Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!