AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Active Member
Posts: 6
Registered: ‎02-20-2013
Message 1 of 1 (171 Views)

user parts

171 Views, 0 Replies
05-01-2013 11:02 AM

I am trying to make user parts by following instructions found in an earler post. I made the XY, YZ, YZ and 3D (using solids) views and defined a new user part. the part with all of its views appears fine in the user parts command ribbon but when i insert it nothing shows up in the drawing. It does show up in the Object Inspector however. Any ideas of what i might be doing wrong?


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.