AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Active Member
Posts: 8
Registered: ‎06-04-2012
Message 1 of 2 (561 Views)

Threaded hole?

561 Views, 1 Replies
06-04-2012 10:53 PM
Is it possible to make a threaded hole with ASD 2012? or is there any posibility to mark some holes as threaded hole? (automatical)
Valued Contributor
Posts: 86
Registered: ‎04-26-2011
Message 2 of 2 (539 Views)

Re: Threaded hole?

06-06-2012 10:07 AM in reply to: lanzman

I have not seen the option to have a threaded hole, however, I have used the bolt command to add in a bolt without a washer or nut and label it "PIN" in the description.  It doesn't change the image from having a hex head, but it is noted with the bolt and can be referanced in tags later.


Hope that helps.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.