AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Active Member
jasonstojakovich7363
Posts: 8
Registered: ‎02-01-2012
Message 1 of 2 (597 Views)
Accepted Solution

Staircase landings help

597 Views, 1 Replies
03-13-2013 10:44 AM

I am trying to create at staircase that starts at ground level, leads to a door @ 11'-0" and continues another 20'-8" opp direction. My problem is that I can not seem to change the # of levels under the parameters of the generator. It keeps showing 9 landings when I know OSHA mandates only after 12'-0" do i need a landing. And to my next point can i create a continious landing on my 2nd stringer. I have attached SC of my drawing this was mainly for practice purposes as I am new to the program. Thanks to all in advance.

Thanks to Jakub from Autodesk he was able to provide a pretty easy answer for those who are having this problem. You need to DEL the top level once the levels are auto populated and use the change level command to enter in the top elev of the stairs and adjust the number of treads. IE  stair height 12'-0". Program populates 4 levels @ 0',4',8'12'. You would delete the top level down to the 4' level and then change level to 12' for a cont stringer.  And again thanks to jakub.!

Active Member
jasonstojakovich7363
Posts: 8
Registered: ‎02-01-2012
Message 2 of 2 (502 Views)

Re: Staircase landings help

03-22-2013 05:52 AM in reply to: jasonstojakovich7363

Thanks to Jakub from Autodesk he was able to provide a pretty easy answer for those who are having this problem. You need to DEL the top level once the levels are auto populated and use the change level command to enter in the top elev of the stairs and adjust the number of treads. IE  stair height 12'-0". Program populates 4 levels @ 0',4',8'12'. You would delete the top level down to the 4' level and then change level to 12' for a cont stringer.  And again thanks to jakub.!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!