AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Mentor
haydenwse
Posts: 191
Registered: ‎10-24-2008
Message 1 of 2 (270 Views)
Accepted Solution

Remove a "fit to object"

270 Views, 1 Replies
07-18-2012 06:03 PM

How do you remove or change the trimming of a profile after you have used the "fit to object" command?

Untitled.png

 on Object inspector, try finding the cut by object you made and remove thereby deleting the cut on the profile.

I hope this helps

 

Valued Contributor
HulelaG
Posts: 54
Registered: ‎09-07-2011
Message 2 of 2 (264 Views)

Re: Remove a "fit to object"

07-18-2012 10:26 PM in reply to: haydenwse

Untitled.png

 on Object inspector, try finding the cut by object you made and remove thereby deleting the cut on the profile.

I hope this helps

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.