AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Distinguished Contributor
mirko.jurcevic
Posts: 223
Registered: ‎01-12-2013
Message 1 of 2 (185 Views)

+/- reinforcement

185 Views, 1 Replies
04-26-2013 06:27 AM

Hi!

Is there a way to display +/- reinforcement? ("on both sides")

 

For example, I have 10#12/15cm (on one side of wall) but I want them to be on both sides of wall (and I want to ASD count it as 20#12 - each side contains 10 bars).

My workaround was to add user comment "+/-" (which means "both sides") and copy that series (to count it twice), but problem occurs when I have a lot of such cases and when I change some of them - it's prone to errors.

 

Same problem with wire fabric. My workaround there is to set layers option to "2".

 

Am I missing some option maybe?

INTELIKA

Mirko Jurcevic M.Eng.
INTELIKA d.o.o.
www.intelika.hr
Distinguished Contributor
mirko.jurcevic
Posts: 223
Registered: ‎01-12-2013
Message 2 of 2 (143 Views)

Re: +/- reinforcement

04-30-2013 04:26 AM in reply to: mirko.jurcevic

Anyone?!

INTELIKA

Mirko Jurcevic M.Eng.
INTELIKA d.o.o.
www.intelika.hr
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.