AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Active Member
danielledew
Posts: 9
Registered: ‎11-11-2008
Message 1 of 2 (412 Views)

Making slight changes to connections

412 Views, 1 Replies
10-18-2010 01:07 AM

Hi.

 

Something I've encountered while working with ASD is that you cannot make slight modifications to a connection without it defaulting back to how it was. For example, there is not option to give a plate a horizontal offset in a connection, so when I go and manually move a plate after placing the connection it will move and look fine, until I either update or modify the connection.

 

I understand why it does this, but our South African standards aren't fully catered for in ASD, so then the easiest workaround is to create a connection and then modify it to suite our standards.

Does anyone perhaps know if there's a way to explode a connection so that these minor changes will be possible?

 

Thanks!

Valued Contributor
tony
Posts: 62
Registered: ‎02-08-2011
Message 2 of 2 (259 Views)

Re: Making slight changes to connections

02-08-2011 08:16 PM in reply to: danielledew

You can try to save the connection after you make the changes then It shouldn't default back

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.