AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Valued Contributor
86 Posts
7 Kudos
Registered: ‎04-26-2011
Post 1 of 2

Hangup while creating a "group" of 3D models

293 Views, 1 Replies
08-19-2011 11:32 AM

It keeps asking for the UCS and you can't "ESC", exit out the window, enter anything that will produce anything but it asking for you to pick the object for the UCS again.  I have to use task manager to close it, and no error report gets produced.  It doesn't save or try and restore.  It's just lost.  I attached a screen shot.

New Member
1 Posts
0 Kudos
Registered: ‎10-26-2010
Post 2 of 2

Re: Hangup while creating a "group" of 3D models

08-22-2011 11:52 PM in reply to: tedmail

Hi, I had a similar incident and only to find that if there are no connections to identify it will not make the group.

since your model is seen as parts and not assembly.

try making Connections, then Group them, and make Auto positioning.

it worked for me in that manner.

 

 

Godfrey makhubela
0846889901
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.