AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Contributor
derrick.lambrecht
Posts: 12
Registered: ‎12-19-2012
Message 1 of 3 (516 Views)

Drawing Orientation

516 Views, 2 Replies
03-13-2013 09:44 AM

When detailing parts and assemblies, it seems to have switched the part orientation. Using the world coordinates for both the part postition and the assembly postition, it appears the assembly postition was rotated by 180 degrees. Why does this happen? If using world coordindates for both, should they both be the same orienatation? Please find the attached PDF.

Contributor
selmir
Posts: 11
Registered: ‎05-20-2013
Message 2 of 3 (339 Views)

Re: Drawing Orientation

07-10-2013 10:40 AM in reply to: derrick.lambrecht

Does anyone have an aswer for this? My drawing is showing the reverse side of my assembly and I cant figure out how to change the orientation.

Valued Contributor
Jianna
Posts: 78
Registered: ‎04-21-2012
Message 3 of 3 (330 Views)

Re: Drawing Orientation

07-10-2013 11:56 AM in reply to: selmir

Have you tried changing the coordinate system of the part? Right click on your piece mark in the "Positions" tab of the object inspector, then click "Change coordinate system".

See attached screenshot.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.