Hi, do anyone have information about of definition of a new user part procedure.
I've been trying with user guide help but i think is not too clear.
I have been trying to follow their instructions on this, as well without any luck. I have a handrail bracket I would like to have as a user part. Not too much more than a bent bar with a round plate, but I cannot make it a user part. Should it be a 3D model? Mesh? Block? It just says to select objects... and nothing seems to work. When I try "define new" using the block method, nothing happens. It's like I didn't even click the button.
Basically, I think it's this GUI that is confusing and the lack of instruction on how to doesn't help. Anyone figure this out yet?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.