AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Contributor
rikmayall
Posts: 24
Registered: ‎02-20-2013
Message 1 of 2 (139 Views)

Defining one sheet within 'Wire fabrics distribution'

139 Views, 1 Replies
04-19-2013 07:23 AM

I have deined a wire fabric within cross section and I am trying to define one sheet of A393 wire fabric mesh on plan by selecting 'Wire fabrics distribution' but it automatically assumes I want more than one sheet - and I have to enter a lap splice distance (although there won't be any lap splice).

 

How can I define just one sheet (it'll be 1500x1500)?

Distinguished Contributor
mirko.jurcevic
Posts: 223
Registered: ‎01-12-2013
Message 2 of 2 (117 Views)

Re: Defining one sheet within 'Wire fabrics distribution'

04-19-2013 02:29 PM in reply to: rikmayall

If I understood your question correctly...

 

I draw area for placing reinforcement manually (big area), click OK, then, choose desired mesh and put it in the drawn area. OK.

Then copy that mesh, and paste it outside reinforcement area. You can copy and resize those (copied) mehes as much as you want, program count's them.

Also, you can now delete reinforcement placing area (together with the first placed mesh).

 

Hope this helps

INTELIKA

Mirko Jurcevic M.Eng.
INTELIKA d.o.o.
www.intelika.hr
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.