AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Contributor
ibnmessaoud10
Posts: 13
Registered: ‎04-24-2010
Message 1 of 2 (999 Views)
Accepted Solution

Bracing type V or K

999 Views, 1 Replies
08-26-2012 01:58 AM

in macros ,only X bracing is done in ASD;

if someone can give a short video to do ( manually) other bracings such as V (inversed) or K .

I tried to use plate welded to profile flange (wich are defined in XY plane),and use machining command to do this...

Please look here where I showed some idea.

---------------------------------------------
If this post answer your question please click "Accept as Solution". It will help everyone to find answer more quickly!

Product Support
Jakub.Brozonowicz
Posts: 317
Registered: ‎12-13-2010
Message 2 of 2 (976 Views)

Re: Bracing type V or K

08-27-2012 08:29 AM in reply to: ibnmessaoud10

Please look here where I showed some idea.

---------------------------------------------
If this post answer your question please click "Accept as Solution". It will help everyone to find answer more quickly!



Jakub Brożonowicz
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.