AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Valued Mentor
JohnHolder
Posts: 460
Registered: ‎04-08-2010
Message 1 of 1 (211 Views)

Bent Plate

211 Views, 0 Replies
07-12-2013 03:43 PM

Attempting to bend a plate once again.

 

a plate, 109.473" wide by 57.5" tall ( standing vertically ) 3/8" width.

bent around a 151-1/16" Arc.

 

basically there are 9 plates around at 25.18" diameter circle.

 

All bolted together.

 

then a bent profile - angle iron around the outsides of both the top and bottom.

top angle is the edging of the tank, and to bottom angle is bolted to the tank foundation ( concrete )

 

it just does not want to bend.  

 

any ideas?  I figured this should have been made much easier than it was a couple releases ago, but no.  still a nightmare.

 

John.

An education isn't how much you have committed to memory, or even how much you know. It's being able to differentiate between what you know and what you don't.
-------------------------------------
"Do or do not... there is no try"
Master Yoda.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.