Hello every one I need help on bending a plate I keep on getting the same message eventhough I change the ucs view
Here is how I do it :
Command: '_-view Enter an option
3DORBIT Press ESC or ENTER to exit, or right-click to display shortcut-menu.
Select plate(s) :1 found
Select plate(s) : Choose method [by2points/byLine]<by2points>:L
Select line: Location of bending line[Center/Edge] <Center>
Specify internal radius or [Axial] <0.125000>:
Specify angle <90.000000>
Pick side to be wrapped :
*** Cut plane does not intersect selected part #1 ***
I changed the view to all views to WORLD, TOP, BOTTOM, LEFT RIGHT, FRONT & BACK but the error is always the same : *** Cut plane does not intersect selected part #1 ***
Thank you very Much
I assume it just doesn't work? I get the same results as described and have not been able to bend the plate.
Actually, after finally playing around with it quite a bit, and knowing I tried these exact same steps before, I was able to get the bend done. Things to take note of:
The Z coordinate should be perpendicular to the face of plate.
180 degree bend is actually not a bend at all, but keeping it flat.
The radious should be .1 and go up from there to get your desired bend.
But at least it gets the job done...
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.