AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Active Contributor
abbakeer
Posts: 40
Registered: ‎11-09-2008
Message 1 of 1 (287 Views)

ASD/ Reinforcement/splice length scale factor

287 Views, 0 Replies
05-04-2009 01:31 AM
If the scale factor ( the value multiplied by the bar diameter in Job prereference ) of the bar lap splice has been changed, the lap length is not affected in surface distribution option.

If the bar diameter ( in surface distribution fill-in form ) has been changed, the lap length is not affected in surface distribution option.


I enter the splice length value manually!!!

Please advise and help. Edited by: abbakeer on Jun 9, 2009 5:45 AM
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!