AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Active Member
csammons
Posts: 7
Registered: ‎02-28-2008
Message 1 of 4 (630 Views)

ASD 2013 - Limited number of layout tabs?

630 Views, 3 Replies
09-25-2012 11:13 AM

I am able to create up to 5 tabs per model and file, but if I try to create another layout, I lose a layout tab or two.

Valued Contributor
tedmail
Posts: 86
Registered: ‎04-26-2011
Message 2 of 4 (626 Views)

Re: ASD 2013 - Limited number of layout tabs?

09-25-2012 12:06 PM in reply to: csammons

You did't lose it...  Look in your "printouts" tab in the object inspector.  If you aren't using the "object inspector" you will have a tough time in ASD.

Active Member
csammons
Posts: 7
Registered: ‎02-28-2008
Message 3 of 4 (625 Views)

Re: ASD 2013 - Limited number of layout tabs?

09-25-2012 01:10 PM in reply to: tedmail

Many thanks. I am using the Object Inspector. I can see the Prinouts, but the number of Layout tabs is limited. I can work around this, but it does not seem necessary to limit the number of layout tabs.

Contributor
Scrambled
Posts: 13
Registered: ‎09-21-2012
Message 4 of 4 (614 Views)

Re: ASD 2013 - Limited number of layout tabs?

09-25-2012 04:42 PM in reply to: csammons

I found this bit of information-

 

type-- setpbuf in the command line.  Change the 5 to 30.  

 

now you get 30 views.

 

 

Steve

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.