We're exploring the use of constraints in ASD.
After we create some 0-layer geometry for a simple steel frame, we apply geometric and dimensional constraints. If you update a dimension, the geometry does too. Works good. Then we create structural HSS profiles from the geometry. When we update the dimension, the profile length does not update to the new dimensional value.
Is there a setting that associates profile member lengths to constrained geometry?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!