AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Contributor
rikmayall
Posts: 24
Registered: ‎02-20-2013
Message 1 of 1 (132 Views)

'Active' Wire Fabric - Cross Section/Plan and Automatic Table Updates

132 Views, 0 Replies
04-16-2013 04:49 AM

How do I show the same wire fabric on both plan and section to come up as the one bar mark and to be updated on a table. At the minute I am creating a Bar Mark for the plan and leaving the section drawing as 'Inactive'.

 

Is there a way to have both 'Active' and to automatically update the table / sections when the surface reinforcement wire fabric information is modified?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.